Advanced Search

High Performance
Sockets & Adapters

September 2010

BGA AdapterActel Device Converter Allow Axcelerator® FPGAs to be used in PCBs designed for Radiation-Tolerant FPGAs

Actel AX2000, 896 pin BGA can be used on an existing 352 position QFP SMT lands via true gull-wing emulation adapter

BURNSVILLE, MN - September, 2010 - Ironwood Electronics' new Actel device converter - DC- AX2000/RTAX2000S-01 allow customers to use a commercial Axcelerator® FG896 package during prototyping, and then switch to an equivalent CQ352 package for production. These device converters can be soldered directly onto the SMT QFP pads using standard solder methods. The characteristics one should consider when selecting a QFP package emulation adapter are as follows: a) surface mountable - both hand soldering as well as reflow process compatible b) durable c) reduced stress on target board d) true gull-wing lead design and e) access to the leads.

The Ironwood Electronics device converter DC- AX2000/RTAX2000S-01 consists of footprint and pin out conversion multi layer PCB with a true gull-wing lead adapter for SMT processing. The gull-wing leads are constructed with a precise lead frame assembly to accomplish the accurate QFP package emulation. DC- AX2000/RTAX2000S-01 is designed to receive AX2000 Actel Axcelerator® Family FPGAs on the top and converts pin mapping to RTAX2000S Actel Radiation-Tolerant FPGAs. This allows low-cost prototyping methods for the RTAX-S packaged in CQFP or CCGA, using the Axcelerator® family Fine Pitch Ball Grid Array (FBGA) or Ceramic Land Grid Array (LGA) as a prototyping vehicle. A complete list can be seen in the following link.

Pricing for the DC- AX2000/RTAX2000S-01 is $1090.00 at qty 1 with reduced pricing available depending on quantity required.

Sultan Faiz
11351 Rupp Dr.
Suite 400
Burnsville, MN 55337

Tel: 952-229-8200 or (800) 404-0204
Fax: 952-229-8201

©2020 Ironwood Electronics. All rights reserved. Privacy Policy